What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 28.06.2025 01:40

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
There are two important concepts here.
Illum autem fuga doloremque est quod delectus id.
These are simplified answers to the original question, and does not change anything I wrote above.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
The S&P 500 closes at 6,000 as bulls aim for return to record territory - MarketWatch
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
What is lightning?
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Rory McIlroy addresses driver situation and the 81 he shot in practice at Oakmont - NBC Sports
(Dc diagram shown, AC is similar).
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–10–16 [ OO OLAOYE OYEBODE ]
Seven years later, Nintendo fans beat Switch game even the devs didn’t - Polygon
but I think this circuit , shows a few more pieces.
A fuse is a non-resetable over current circuit protector.
But it can get overloaded, and no longer works.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Upvotes:
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
A Cosmic Tech Mystery Results in Literal Lost Souls in This Sci-Fi Short Story - Gizmodo
eight
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
It seems Mohan does not understand the difference between a comment and an Answer.
This is where this question deviates from being a 'generic' question, and becomes more specific.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
I post the exact comment here.
Vienna calling: Strauss's 'Blue Danube' waltzes into outer space - Phys.org
There are three different concepts here that are getting confused.
2024–10–10[John johnson John Johnson ]
One
US Food and Drug Administration Launches AI Platform to 'Modernize' Agency - Decrypt
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
At one ohm, the resistor has a maximum of 1 watt power.
The MOV will conduct when the voltage exceeds 50% of line voltage.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Edit 2024–10.
The bolt then partially travels down the line to your home.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
What does a fuse do?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
He then describes Rainy Season and Lightning.
2024–10–14 [Omar Gharbi Omar Gharbi ]
A circuit breaker is similar, but is resettable.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
what exactly is a ‘surge’ protector?
The other is “what does a “fuse” do?”
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
but this device (an Inductor) … impedes the rapid changes in the current.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
the problem then depends on "how fast does the fuse operate?".
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
One is “what exactly is in a ‘surge protector’ ? ”
These devices are installed between the “hot” and “neutral” and protective ground.
For this case there are devices called Metal oxide varistors (MOV).
a photo is worth a thousand words.
It also is a device that limits the change in current flow.
Because the load is inductive, the current lags the voltage.(by a bit).
First Sentence:
In schematic diagrams this is the symbol for a fuse:
This device then solves the entire problem.
This is 'the assistant's answer'
He then asserts :
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
This one hit behind the barn.
nine
But… the neutral is now “floating” because of the 1 ohm resistance.
This is where the MOV conducts again, and dissipated the energy.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
So, the voltage could go up to 500 volts, and the fuse will not open up.
He then describes the function of a fuse.
[image of Common-mode choke]
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
so, what happens?
[old diagram got deleted by accident]
Barnstars:
An AC voltage/ current source, and an ac inductive load.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
At least they know the answer if they wanted it.
Here is a simplified AC power diagram.
Now when you have a certain ac resistance, then a current flows in a loop.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
The third is lightning and “how it gets conducted into a home.”